Mandatory Hook For Starting Socks
Step 1. Mouse
There's always the same knitting. For the thread ring, connect eight half-stops and close the connector to the 1st loop.
Figure 1 shows the number of rows corresponding to size.
In the 2nd row, the number of hinges is doubled = 16 h.
Starting from the 3rd row, in each row knitting adds Four loops.
Work to continue in a straight and reverse direction by the rows, i.e., after the coupling, to turn the row into the middle of the lower leg. If necessary, the right and left medium loops shall mark the contrast thread.
Step 2. Step, step and foot rise
In order to tie a half-century without hinges and to perform as many rows as indicated in the table below or in the model instructions. The transition from a number to a row continues to mark the contrast thread, moving it upwards.
Then, in each row, start adding loop and stain hinge loops, before and after the right middle loop, and in front and after the left medium hinge, two half-size. The number of rows with additives is indicated in the model instruction or is determined by the table:
Step 3. Sten of stain
For the wall of the stain, tie the poles without naquid under scheme 2 (see below). If the last row with the additives was facial, after turning, as shown in the chart, by means of coupling poles, to the edge of the fifth wall, to tie the end of the hinge of the stains, to turn and continue the work on the scheme. If the last row with the additives was intelligent, first by means of connecting pillars, go to the edge of the stain wall and tie one hinge from the side edge of the stain, turn and
